A-12
CLI Reference Guide for the Cisco Secure Access Control System 5.1
OL-18996-01
Appendix A ACS Command Reference
EXEC Commands
Example 8 – Failure
acs/admin# acs-config
Escape character is CNTL/D.
Username: acsadmin
Password:
Administrator must change password.
Old password:
New password:
Confirm new password:
Cannot change password:
Value is out of range (4 - 32)
acs/admin#
If the new password does not conform with the password policy, ACS displays the password policy
details as shown in the previous example.
Related Commands Command Description
acs (instance) Starts or stops an ACS instance.
acs (process) Starts or stops an ACS process.
acs backup Performs a backup of an ACS configuration.
acs-config Enters the ACS Configuration mode.
acs patch Installs and removes ACS patches.
acs reset-config Resets the ACS configuration to factory defaults.
acs reset-password Resets the ‘acsadmin’ administrator password to the default setting.
acs restore Performs a restoration of an ACS configuration.
acs support Gathers information for ACS troubleshooting.
backup Performs a backup (ACS and ADE OS) and places the backup in a
repository.
backup-logs Backs up system logs.
debug-log Defines the local debug logging level for the ACS components.
export-data Restores to the default local debug logging level of the ACS
components.
replication force-sync Synchronizes the secondary ACS database to the primary ACS
database.
restore Restores from backup the file contents of a specific repository.
show debug-adclient Shows the debug log level status for subsystems (enabled or disabled).
show acs-logs Displays ACS server debug logs.
show application Shows application status and version information.
show version Displays information about the software version of the system.
To Next Page
Loading...
