Cisco SCE8000 Configuration Guide

5-11
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 5 Configuring the Management Interface and Security
Configuring the Available Interfaces
• key-string — encryption key that the server and client will use when communicating with each
other. Make sure that the specified key is actually configured on the TACACS+ server host.
– Default = no key or user-configured global default key (See How to Define a Global Default
Key, page 5-11.)
Step 1 From the SCE(config)# prompt, type tacacs-server host host-name [port portnumber] [timeout
timeout-interval] [key key-string]
and press Enter.
How to Remove a TACACS+ Server Host
Options
The following options are available:
• host-name — name of the server to be deleted
Step 1 From the SCE(config)# prompt, type no tacacs-server host host-name and press Enter.
How to Configure the Global Default Key
Use this command to define the global default key for the TACACS+ server hosts. This default key can
be overridden for a specific TACACS+ server host by explicitly configuring a different key for that
TAC ACS+ s erver host.
Options
The following options are available:
• key-string — default encryption key that all TACACS+ servers and clients will use when
communicating with each other. Make sure that the specified key is actually configured on the
TACACS+ server hosts.
– Default = no encryption
How to Define a Global Default Key
Step 1 From the SCE(config)# prompt, type tacacs-serverkey key-string and press Enter.
How to Clear the Global Default Key
Step 1 From the SCE(config)# prompt, type no tacacs-server key and press Enter.
No global default key is defined. Each TACACS+ server host may still have a specific key defined.
However, any server host that does not have a key explicitly defined (uses the global default key) is now
configured to use no key.

Cisco SCE8000 Specifications

General

Brand	Cisco
Model	SCE8000
Category	Network Hardware
Language	English