Citizen CL-E700 Series - Printer Menu Setup Mode Operations

Chapter 2 Operating Principles
2-2.
Operation of Control Parts
2-21 CL-E700 series
(1) CPU
The CPU is a microprocessor with 32-bit architecture. The clock fed to the CPU is 48 MHz.
The CPU internally multiplies this 48 MHz by 8 times and uses 384 MHz clock. The CPU
includes cache memory, RAMs, DMA controller, serial I/F, USB function controller, LAN
function controller, A/D converter, etc.
(2) Flash ROM
A flash ROM of 128M bits (16M bytes) that stores the firmware and CG (character generator).
(3) SDRAM (Synchronous dynamic RAM)
A SDRAM of 256M bits (32M bytes) that is used as working area, input buffer and download
buffer
(4) FPGA
The FPGA (Field-Programmable Gate Array) incorporates a control circuit for the interface I/O
port, motors, print head, etc.
(5) Head control
This is a circuit to control the thermal head driver incorporated in the thermal head. It also
checks if a thermal element of the thermal head is faulty.
(6) Stepping motor driver (For “SA PF Motor”)
This is a circuit to drive the “SA PF Motor”. The “SA PF Motor” is a stepping motor.
(7) Stepping motor driver (For “SA Ribbon Motor F”)
This is a circuit to drive the “SA Ribbon Motor F”. The “SA Ribbon Motor F” is a stepping motor.
(8) Buzzer
The buzzer is driven when an alarm, etc. occurs.
(9) DC Fan (SA Fan)
A cooling fan for the “SA Ribbon Motor F”. When the temperature of the “SA Ribbon Motor F”
exceeds a certain value, the fan starts to work.