Citizen CL-E700 Series Technical Manual

Chapter 2 Operating Principles
2-3.
Operation Panel
2-57 CL-E700 series
[Print sample]
Machine Information
Model Number : CL-E720
Serial Number : **-*******
Boot Version : *.*
ROM Version : ********
ROM Date(DD/MM/YY) : **/**/**
ROMCheck Sum : ****
FPGA Version : ***.***
Head Check : OK
Print Counter : 0002.2km
Service Counter : 0002.2km
Cut Counter : 0
Sensor Monitor : 2.73V
Option Interface : None
MAC Address : **.**.**.**.**.**
Factory Mode Settings
Through Sensor Positon : 0 dot
Reflect Sensor Position : 0 dot
Machine Tear Position : 0 dot
Machine Cut Position : 0 dot
Machine Peel Position : 0 dot
Machine Horizontal Pos. : 8 dot
AutoCal Mode : On
See Through Sensor : 0.0 V
Reflect Sensor : 0.0 V
SeeThrough Sensitivity : Low
Reflect Sensitivity : Low
Through Cal Level : 2.30 V
Reflect Cal Level : 2.10 V
SensNone Cal Level : 2.05 V
Darkness Rate : High
Double Heat Menu : Off
TT Hot HeatRate Adjust : 0.0%
TT Cold HeatRate Adjust : 0.0%
DT Hot HeatRate Adjust : 0.0%
DT Cold HeatRate Adjust : 0.0%
PowerOn Head Check : On
Head Check Start Pos. : Dot 1
Head Check Stop Pos. : Dot 848
Head Error Print : No
Ribbon Control : Auto
Ribbon End Detection : Normal
Void to TOF : Off
Reverse Media Length : 0.00 inch
Min Cut Length : Default
Paper End Sensor : On
Paper End Length : Default
Parallel Error Output : On
Auto Online : Off
Auto Online Delay : 2 sec
Top Form Sensing : On
USB Serial Number : Off
Auto Exec Print : On
Config Print Layout : Standard
Head Clean Message : Off
Print Preference : Darkness
Note:
Citizen continually enhances its
printers with new options and
settings based on our customer’s
requests. Extra or changed menu
items may appear on the print out
in some cases.
Submenus for maintenance only

Citizen CL-E700 Series Specifications

General

Brand	Citizen
Model	CL-E700 Series
Category	Printer
Language	English