Codan 9390 - Page 125

Setup procedures (part 3)
9390 Reference manual 7-9
Action Notes
3.
To switch between
‘
ENABLED
’ and
‘
DISABLED
’, rotate
Select
Select:
• ‘
ENABLED
’ if you want to
display a message when you
switch on the transceiver
• ‘
DISABLED
’ if you do not
want to display a message
when you switch on the
transceiver.
4.
To save your change,
press
F2
If you selected ‘
ENABLED
’:
CLEAR
Modify message
Power Up Message
ENTER
– – – – – – – – – – – – – – – – – – – –
If you selected ‘
DISABLED
’:
EXIT
POWER UP MENU
2–Mute
ENTER
3–Show ID
1–Message
5.
Did you select
‘
ENABLED
’ to display a
power up message?
Yes  Step 6.
No  Step 8.