Codan 9390 User Manual

Using Setup mode procedures
4-2 9390 Reference manual
Using Setup mode
You enter Setup mode by pressing the
Mode
button on the
control panel four times starting with the Channel mode
setting.
The easiest way to use Setup mode is to find which procedure
you want from the following list and turn to the description of
the procedure for further details and step by step guidance.
Procedures are listed in Chapters 5–8.
You start each transceiver procedure by entering a setup
code.
Procedures labelled optional are only available if you contact
Codan for a password to enable them in your transceiver (see
Chapter 7, Password entry to enable transceiver options).
If you make a mistake in setting a value and want to avoid
saving your changes, press the
F1
button on the control panel
or
PTT
button on the microphone to return to an earlier step
in the procedure. Repeated pressing of either button
progresses you back to Channel mode.
If you do not touch any button or knob for 60 seconds while
in Setup mode, the transceiver automatically reverts to
Channel mode. If this happens while you are in the middle of
a procedure, start the procedure again.
The descriptions for the procedures show examples of
channel and frequency numbers. You must enter your own
values.


Codan 9390 Specifications

General

Brand	Codan
Model	9390
Category	Transceiver
Language	English