Setup procedures (part 4)
9390 Reference manual 8-21
Telcall availability on/off (option)
Setup code 22
This procedure controls whether your transceiver can send
telcalls.
Before you can use this procedure, you need to enable the
selcall option (see Chapter 7, Password entry to enable
transceiver options).
For information on telcalls, refer to the 9390 User guide,
Chapter 5, Telcall.
To switch the availability of telcalls on or off:
Action Notes
1.
Repeatedly press
Mode
until you see the display
for Setup mode.
The display shows:
EXIT
SETUP MENU
1- Scan-
2–Call
ENTER
3–Config
4–More
1/2
2.
Enter 22
numeral
buttons
The display shows:
EXIT
Telcall enabled
ENTER
ENABLED
Telcall Setup
or
EXIT ENTER
DISABLED
Telcall Setup
Telcall disabled
To Next Page
Loading...
Need help?
General
