Setup procedures (part 4)
8-26 9390 Reference manual
99-beacon call response on/off (option)
Setup code 241
This procedure controls whether your transceiver can respond
to a received 99-beacon call (selective call ending in 99).
The transceiver responds to a 99-beacon call by transmitting
a beacon signal of four long tones.
Before you can use this procedure, you need to enable the
selcall option (see Chapter 7, Password entry to enable
transceiver options).
To switch the transceiver’s response to 99-beacon calls on or
off:
Action Notes
1.
Repeatedly press
Mode
until you see the display
for Setup mode.
The display shows:
EXIT
SETUP MENU
1- Scan-
2–Call
ENTER
3–Config
4–More
1/2
2.
Enter 241
numeral
buttons
The display shows:
EXIT
99Beacon enabled
ENTER
ENABLED
99Beacon Setup
or
EXIT ENTER
DISABLED
99Beacon Setup
99Beacon disabled
To Next Page
Loading...
Need help?
General
