Setup procedures (part 1)
9390 Reference manual 5-9
ALE option reset (option)
Setup code 2432
This procedure resets 9 of the 17 ALE (Automatic Link
Establishment) option settings 0–16 to their factory values.
Before you can use this procedure, you need to enable both the
selcall and ALE options (see Chapter 7, Password entry to
enable transceiver options).
To reset the ALE option settings:
Action Notes
1.
Repeatedly press
Mode
until you see the display
for Setup mode.
The display shows:
EXIT
SETUP MENU
1- Scan-
2–Call
ENTER
3–Config
4–More
1/2
2.
Enter 2432
numeral
buttons
The display shows:
EXIT ENTER
Press ENTER to reset
ALE system options
3.
Press
F2
The display shows:
EXIT ENTER
Press ENTER again to
reset ALE options
To Next Page
Loading...
Need help?
General
