Channel and scan table setup
3-24 9390 Reference manual
Creating a scan table
This procedure sets up any of the three scan tables.
You can only make changes to scan tables if scan table
editing is switched on (see Chapter 8, Scan table editing
on/off).
Each scan table can hold up to ten channels. You can add a
channel to the scan table more than once if you want the
channel to be scanned several times in each scan cycle.
You can select one of several scan types as displayed:
‘
Selcall
’
(option)
Selcall scanning is the normal setting if you have
enabled the selcall option and you expect to
receive selcalls. Mute is on so that no voice
transmissions are heard. (Use of selcall mute
needs to be on. See Chapter 8, Selcall mute
availability on/off.)
Each channel is scanned for 0.6 seconds.
Scanning only stops for selcalls.
‘
Cont
’
Use Continuous scanning if you want to listen to
voice traffic as the channels are scanned.
Each channel is scanned for 0.6 seconds.
Scanning only stops for selcalls. Mute is off.
‘
Pause
’ Use Pause scanning if you expect voice calls and
want scanning to pause for five seconds when
voice is detected on the channel.
Each channel is scanned for one second unless
voice is detected. Scanning also stops for
selcalls.
To Next Page
Loading...
Need help?
General
