9390 Reference manual 9-1
9 Link Setup mode
Link Setup mode allows you to access transceiver options
that affect transceiver operation and security.
This chapter describes the following Link Setup procedures:
• Link Setup mode enter/exit (9-2)
• Antenna band or channel control (9-5)
• PIN setup (9-7)
• Setup mode availability on/off (9-10)
• Transceiver reset to factory settings (9-12).
If you make a mistake and want to exit half way through a
Link Setup procedure, press the
F1
button on the control
panel or
PTT
button on the microphone. This will return you
to the start of Link Setup mode without making any changes.
To Next Page
Loading...
