Setup procedures (part 3)
7-2 9390 Reference manual
Password entry to enable transceiver options
Setup code 42
This procedure allows you to:
• display your transceiver ID
• enable transceiver options that are built into the
transceiver
• delete your PIN if you have forgotten it.
By using passwords, you can purchase additional features for
your transceiver without the need to return the unit to your
Codan agent.
You obtain passwords from your Codan agent. There is a
separate password for each transceiver option. Passwords are
unique to your transceiver. You cannot use your transceiver’s
passwords with a different transceiver.
Enabling transceiver options
The table below lists the passwords available from Codan for
enabling transceiver options.
Password Option
ALE Allows you to add an ALE controller to
your system so that you can send and
receive ALE calls. Refer to the 9390 User
guide, Chapter 5, ALE call. The selcall
option must be enabled.
AM Allows you to transmit on AM using any of
the transceiver’s transmit channels. If AM is
not enabled, you can only transmit on AM
using the 2182kHz marine distress
frequency on channel 1.
To Next Page
Loading...
Need help?
General
