Setup procedures (part 4)
8-16 9390 Reference manual
Selcall lockout on/off (option)
Setup code 2441
This procedure switches selcall lockout on or off.
Before you can use this procedure, you need to enable the
selcall and selcall lockout options (see Chapter 7, Password
entry to enable transceiver options).
Selcall lockout prevents you from sending selective calls if
the transceiver detects that another station is already in the
process of sending a selective call on the same channel. This
reduces call interference between stations and increases the
chance of success when your call is transmitted.
Selcall lockout does not apply to voice, distress or tone calls.
To switch selcall lockout on or off:
Action Notes
1.
Repeatedly press
Mode
until you see the display
for Setup mode.
The display shows:
EXIT
SETUP MENU
1- Scan-
2–Call
ENTER
3–Config
4–More
1/2
To Next Page
Loading...
Need help?
General
