Setup procedures (part 4)
8-4 9390 Reference manual
Scan table editing on/off
Setup code 12
This procedure switches scan table editing on or off.
After you have set up your scan tables, switching scan table
editing off safeguards against accidentally deleting or
modifying scan table information. For details on setting up
scan tables, see Chapter 3, Creating a scan table.
When scan table editing is switched off:
• you cannot set up, delete or modify any scan table
• you cannot use the transceiver’s automatic scanning start
feature if no scan tables have been set up (see Scan table
automatic scanning start on page 8-2).
To switch scan table editing on or off:
Action Notes
1.
Repeatedly press
Mode
until you see the display
for Setup mode.
The display shows:
EXIT
SETUP MENU
1- Scan-
2–Call
ENTER
3–Config
4–More
1/2
To Next Page
Loading...
Need help?
General
