Codan 9390 - Tone Call Setup

Setup procedures (part 4)
9390 Reference manual 8-23
Tone call setup
Setup code 23
This procedure sets up the high and low frequency pairs for
any of the four tone call groups T1–T4.
Having set up a tone call group, you can assign the group to
any channel.
You can set frequencies in the range 300–2800Hz. If you
want a tone call group to use a single frequency, set either the
high or low frequency to 0Hz.
To set up a frequency pair for a tone call group:
Action Notes
1.
Repeatedly press
Mode
until you see the display
for Setup mode.
The display shows:
EXIT
SETUP MENU
1- Scan-
2–Call
ENTER
3–Config
4–More
1/2
2.
Enter 23
numeral
buttons
Example of the display:
EXIT PROGRAM
Hi: – – – – Hz Low:– – – – Hz
Tone Pair: 1