Codan 9480 User Manual

Programming channels
9480 HF SSB transceiver 7-3
Checking if the inhibit link is fitted to the PCB
In this mode, all channels may be overwritten or deleted from the front panel. This
facility is only available when there is no Inhibit link fitted to the microprocessor
PCB.
Step Action… Display shows… Remarks…
1.
Turn the
transceiver off
and move the
front panel link to
position 1.
No display. Before moving the link,
note its original position.
Refer to Section 8,
Changing the position of
the front panel link.
2.
Hold down
Enter
and press
On/Off
Hold down the Enter
button until the display
shows
Note: If there is an
Inhibit link fitted, the
display shows whichever
inhibit has been selected.
This display confirms
that no Inhibit link is
fitted to your transceiver.
The message means that
there are no inhibits on
channel programming.
3.
Press
On/Off
No display. The transceiver is now
switched off.
4.
Replace the cover
before switching
on your
transceiver.
Refer to Section 8,
Changing the position of
the front panel link.
q

Codan 9480 Specifications

General

Brand	Codan
Model	9480
Category	Transceiver
Language	English