Programming channels
7-6 9480 HF SSB transceiver
Creating receive only channels
All transceivers have the facility to create or change the receive channels from the
front panel.
Ensure your transceiver is switched on before commencing this procedure.
Step Action… Display shows… Remarks…
1.
Press
Enter
Your next action must
start within 60 seconds.
2.
Press
0
B’con
3.
Use the numeric
buttons to enter
the receive
frequency.
If the display shows
either a ‘too hi’ or ‘too
lo’ error message, refer
to page 7-12,
Programming display
messages.
The frequency must be
entered to the nearest
100 Hz, between
250 kHz and 30 MHz.
The display shows an
example of 5 MHz.
4.
Press
Enter
This facility defaults to
the last channel setting.
To Next Page
Loading...
Need help?
General
