Using the receiver in scan mode
9480 HF SSB transceiver 6-7
Changing the scan mode
There are three voice scan mode options available to you which can be selected by
repeatedly pressing the Mute button. Your transceiver must be in scan mode to
complete this operation (refer to page 6-6, Receiving in scan mode).
• Pause scanning. Scanning stops for five seconds when an audio signal is detected.
• Hold scanning. Scanning stops when an audio signal is detected, and continues
only when the signal ceases.
• Continuous scanning. Each channel is monitored for one second. Scanning
continues regardless of any audio signals being detected.
Note: scan modes operate for both voice and selective call reception
Step Action… Display shows… Remarks…
1.
Ensure the
transceiver is in
scan mode.
The display shows the
frequencies as they are
scanned.
The Scan indicator is lit
in Scan mode.
Refer to page 6-6,
Receiving in scan mode.
2.
Pause scanning
Press once
Mute
Voice
S’Call
You hear a single ‘pip’
and the Voice indicator is
lit.
If you want Hold
scanning, go to step 3.
To exit this mode go to
step 5.
To Next Page
Loading...
Need help?
General
