Using the receiver in scan mode
6-6 9480 HF SSB transceiver
Receiving in scan mode
This procedure covers three topics when receiving in scan mode:
• start scanning
• stop scanning
• changing the scan mode.
Start scanning
Step Action… Display shows… Remarks…
1.
Press
Scan
The display shows details
of each channel as it is
scanned.
The Scan indicator is lit
during scanning.
Notes: You cannot transmit while the transceiver is in scan mode. If you attempt to
transmit, you hear a single ‘pip’ and the error message ‘No PTT Error’ is
displayed.
If you need to transmit, you must stop the scanning operation.
q
Stop scanning
Step Action… Display shows… Remarks…
1.
Press
Scan
or press the
microphone PTT
button twice.
The display shows the
last channel scanned.
The Scan indicator is no
longer lit.
Note: If you only press the PTT button once, the display shows ‘NO PTT Error’
q
To Next Page
Loading...
Need help?
General
