Changing the setup options
9480 HF SSB transceiver Error! Main Document Only.-9
Enter a PIN (Personal Identification Number)
If you select a PIN for the transceiver, you have to enter this PIN each time you
switch the transceiver on. If you fail to enter the correct PIN, the transceiver
automatically switches off.
If a PIN code is set, the transceiver can only be operated by entering the PIN.
It is important that every person who uses the transceiver knows the PIN.
Alternatively, do not set the PIN code.
If you forget the PIN, you must return the transceiver to the factory.
Step Action… Display shows… Remarks…
1.
Turn the
transceiver off
and move the
front panel link to
position 1.
No display. Before moving the link,
note its original position.
Refer to the procedure on
page 8-3.
2.
Hold down
3
and press
On/Off
Hold down the numeric 3
button until the display
shows
This switches on your
transceiver in PIN setup
mode.
3.
Use the numeric
buttons to enter
your PIN.
The display shows the
number you enter.
You can select a number
between 1 and 999999.
To Next Page
Loading...
Need help?
General
