Using the receiver in scan mode
6-2 9480 HF SSB transceiver
Setting up the scan mode
The scan program allows your transceiver to scan a selected number of frequencies.
Your transceiver also has the option to run in normal or Auto-scan mode. The Auto-
scan mode automatically puts the transceiver back into scan after five minutes of
inactivity (such as no channel change, PTT and tune). These scan facilities have two
options:
• Enabled—scan programs can be entered and deleted from the front panel
• Inhibit—scan programs cannot be entered or deleted from the front panel.
Step Action… Display shows… Remarks…
1.
With the
transceiver
switched off, hold
down
Scan
and press
On/Off
Hold down the Scan
button until the display
shows
This turns on the
transceiver in scan setup
mode.
2.
Press
Scan
Each press of the Scan
button scrolls to the next
option.
If this is the option you
want, go to step 6.
3.
Press
Scan
Switches to Auto option.
If this is the option you
want, go to step 6.
To Next Page
Loading...
Need help?
General
