Changing the setup options
9480 HF SSB transceiver Error! Main Document Only.-13
Power-on settings
There are two power-on settings that may be set at any time without the need to move
or install any internal links. These are the default settings that are always present
when you switch on the transceiver.
• Mute settings. This facility allows you to select Voice Mute On, Voice Mute
Off, or S’call Mute on.
• Beep volume. This facility allows you to set the beep volume to loud or soft.
Mute settings
Step Action… Display shows… Remarks…
1.
Hold down
Mute
Voice
S’Call
and press
On/Off
Hold down the Mute
button until the display
shows
This switches on your
transceiver in Mute setup
mode.
2.
Press
Mute
Voice
S’Call
No change in the display. The Voice Mute is on
when the Voice Mute
indicator is lit.
If you wish to select
Voice Mute, proceed to
step 4.
If you wish to select
S’call Mute proceed to
step 3.
To Next Page
Loading...
Need help?
General
