Codan 9480 - Beacon Mode

Using selective call
9480 HF SSB transceiver 5-27
(99) beacon mode
Step Action… Display shows… Remarks…
1.
Ensure your
transceiver is
switched on.
The last channel selected.
2.
Select the
required test
channel and tune
the antenna.
Refer to Section 4,
Selecting channels.
3.
Press
Call
When this button is
pressed, the S’call Mute
is automatically switched
off.
4.
Use the numeric
buttons to enter
the required
selective call
number. Use the
first two digits of
the stations self
identification
number and
ensure the last two
are 99.
This sends a signal to the
base station enabled for
beacon call, whose four
digit self-identification
address begins with 13.