Using selective call
Error! Main Document Only.-6 9480 HF SSB transceiver
Setting the fixed called address
There are two ways of entering the called address:
a) as below, which is fixed and cannot be changed easily
b) by the method used on page 5-14, Transmitting a selective call (Open
access selective call) which allows the address to be entered from the front
panel and is easy to change to call another transceiver.
Note: By setting a fixed called address the normal function of Call will
change. If a fixed call address has been set, pressing Call will
automatically send the programmed address. Open access selective
calling is disabled.
Step Action… Display shows… Remarks…
5.
Use the numeric
buttons to enter
the called address
number.
To delete an
address, enter four
zeros.
You can override an
existing address by
entering a new number.
6.
Press
Enter
Once Enter has been
pressed, the called
address has been set and
can only be changed by
repeating this procedure.
If your transceiver has
the pre-set selective
calling switches fitted,
proceed to step 8.
The next step must be
completed within 60
seconds.
To Next Page
Loading...
Need help?
General
