Using the transceiver
9480 HF SSB transceiver Error! Main Document Only.-19
Transmitting a message
Step Action… Display shows… Remarks…
1.
Select a channel
for transmission.
The display shows the
channel number and the
transmit (Tx) and receive
(Rx) frequencies.
Refer to page 4-9,
Selecting channels.
2.
Check the display
to see if the
channel transmit
frequency has
been enabled.
If the display shows
‘inhib’ then the channel
frequency is receive only.
If the channel has been
enabled, continue with
step 3.
If the channel has not
been enabled and the
display shows ‘inhib’,
select another channel on
which to transmit.
3.
Tune the antenna. Refer to page 4-14,
Tuning the antenna.
4.
Listen and check
that the channel is
free from traffic.
To Next Page
Loading...
Need help?
General
