Programming channels
7-12 9480 HF SSB transceiver
Programming display messages
Whilst programming channels, the display may present you with the following
messages:
• inhibit (inhib)
• used (USEd)
• full (FULL)
• too hi or too low (too hi or too lo).
Inhibit (inhib)
Channels can be protected from being accidentally deleted or overwritten by
soldering a link on the microprocessor PCB. (Refer to Section 8, Inserting the
microprocessor PCB link.)
If you try to delete or overwrite a channel with the link installed, the display shows
inhib when you press the Enter button. You must try another channel number in order
to store your selection.
Used (USEd)
If the display shows USEd, the channel number you selected is already being used
and the overwrite protection link is not installed (refer to Inhibit, above). Either enter
another channel number or overwrite the existing channel number by pressing the
Enter button again.
If the overwrite protection link is not installed, pressing the Enter button again
will erase the frequency previously allocated to this channel number.
To Next Page
Loading...
Need help?
General
