Using the receiver in scan mode
6-4 9480 HF SSB transceiver
Programming the channels to be scanned
In normal operating conditions, a maximum of 15 channels can be programmed to be
scanned in sequence for audio (voice) signals. Channels required to operate on a
selective call must be programmed within the first eight entries.
Ensure your transceiver is switched on and scan program has been enabled.
Step Action… Display shows… Remarks…
1.
Press
Enter
and then
Scan
within one
second.
The Scan indicator
flashes.
Any previous channels
programmed to be
scanned are erased.
2.
Select the relevant
channel.
Press
Channel
Refer to Section 4,
Selecting channels.
Channels required to
operate on selective call
must be enabled.
3.
Press
Scan
The channel is
programmed for
scanning.
Repeat this procedure
until all channels you
want to scan have been
programmed.
To Next Page
Loading...
Need help?
General
