Programming channels
9480 HF SSB transceiver 7-13
Full (FULL)
If the display shows FULL, all 15 channels have been used.
If the overwrite protection link is not installed, pressing the Enter button again
will erase the frequency previously allocated to this channel number.
Select a channel number you no longer need. Overwrite this number by pressing the
Enter button again.
If the overwrite protection link is installed, it will have to be removed before you can
save your new channel selection. (Refer to Section 8, Inserting the microprocessor
PCB link.)
Too high or too low (too hi or too lo)
If you try to program a frequency outside the range of 250 kHz to 30 MHz, the
transceiver displays the error message too hi or too lo. To overcome this problem,
reprogram another frequency within the range of the transceiver.
q
Setting up temporary channels
During any channel programming operations, copying or creating a channel, you can
press the Enter button instead of entering a channel number. This creates a temporary
channel which will not be saved when you switch off the transceiver.
q
To Next Page
Loading...
Need help?
General
