Codan 9480 - Page 109

Programming channels
9480 HF SSB transceiver 7-9
Step Action… Display shows… Remarks…
4.
Use the numeric
buttons to enter
the receive
frequency.
Or press
Enter
again if the
receive is the
same frequency as
transmit.
If the display shows
either a ‘too hi’ or ‘too
lo’ error message, refer
to page 7-12,
Programming display
messages.
This example is for
receive frequency 3421.
The frequency must be
entered to the nearest
100 Hz, between
250 kHz and 30 MHz.
5.
Press
Enter
This facility defaults to
the last channel setting.
6.
Press
USB/LSB
Each press of the Mode
button displays the next
sideband option. Stop
when you reach the
option you require.
Refer to Section 4,
Option codes.
7.
Press
Enter
This registers the options
you selected and allows
you to enter a channel
number.