Display messages
9480 HF SSB transceiver Error! Main Document Only.-3
No. of ‘beeps’ Message displayed Meaning
1
An attempt has been made to select
scan mode while the transceiver is
transmitting, or no channels have
been entered in the scan program.
Check that the program has scan
channels, if not select another
program.
1
An attempt has been made to
program a receive frequency higher
than 30,000 kHz or a tone
frequency higher than 2800 Hz.
1
An attempt has been made to
program a channel with a frequency
lower than 250 kHz or a tone
frequency of 300 Hz or lower.
0
All 15 channels are programmed.
1
The nominated channel is already
programmed.
1
There are four program inhibit
options available. Refer to Section
7, Checking if the inhibit link is
fitted to the PCB.
To Next Page
Loading...
