NGT—Channel additions
138 NGT Transceiver System Technical Service Manual
The Receive Freq setting is displayed with the receive frequency of the channel you
were on.
1 Do one of the following:
• to use this frequency, press
• to enter a new receive frequency, type the frequency in kilohertz, then press
The transceiver asks you if you want to disable the transmit frequency of the new
channel.
1 Do one of the following:
• to disable the transmit frequency, press
• to create a channel with the same transmit frequency as the channel you were
on, press
The Mode setting is displayed.
1 Scroll to the mode (or one of the modes) you want to use with this channel.
1 Press to save the mode.
NOTE
To enter lower-case or numeric characters, press the # key until a
lower-case a or the hash symbol # is displayed at the bottom right of
the screen.
The name must be unique to the Channel List.
NOTE
If you are creating a transmit channel, the modes from which you can
select are the allowed modes for the channel you were on.
If you are creating a receive-only channel, the modes from which you
can select are all the modes available in the transceiver.
NOTE
If multiple modes can be added to the channel the transceiver asks
you if you want to add another mode. Do one of the following:
• to add another mode press , scroll to the mode you want to
add, then press again
• if you do not want to add another mode, press
To Next Page
Loading...
