Control Station Duetto Web interface – Customization
2.0/0518 71
Additional event settings
Condition: In this drop-down list, a condition for the previously selected event can be selected(see
page 68), which also has to be fulfilled in order to execute an action. The following condition is
available:
PIN code entered
This event is fulfilled when the code configured in the field below matches with
the PIN code that has been entered in the PIN code dialogue on the display of
the DUETTO device. Therefore, the PIN code dialogue must be displayed on the
display of the DUETTO device with the action PIN code dialogue (see below
).
An example of how to configure a proper PIN code dialogue can be found on
page 139.
NOTE: The PIN code must consist of numbers (0 – 9). Letters are invalid.
Logic tag triggered
This event is fulfilled when:
The action „Logic tag triggered“ is triggered; the same logic tag is assigned, or
A button is tapped on the display; the same logic tag is assigned in the section
Button Type (see page 74
).
NOTES:
In order to save the logic rule, a valid logic tag name must be entered.
Audio device during call
toggled
This event is fulfilled when the active audio device has been toggled during a
call.
GOOD TO KNOW: What is a logic tag?
Logic tags are used to connect elements (buttons or logic rules). For example, a button click can be used
as a trigger ("Event") of a "Logic Rule". Conversely, "Logic Rules" can execute "Actions" that change the
behaviour of buttons. In both examples, the mapping is carried out with the help of logic tags. It is pos
-
sible to define multiple logic tags for each DUETTO device.
Event conditions
is In order to fulfill the event, the event value (e.g. SIP call number)
has to match the entire entry in the lower field.
is not In order to fulfill the event, the event value (e.g. SIP call number)
must not match the entry in the lower field.
any The event is fulfilled by any event value.
Phone number
You can enter a value or wildcard between {{[0-9]}}, a range of arithmetic
values or a list of values. For more information about wildcards see ”
Wild-
cards (variables)” on page 75.
Condition Function
Pending calls
The condition is fulfilled when the selected number of calls (regardless of
call type) is pending on the DUETTO device (0 = no pending calls active;
i.e.
these calls have not been accepted yet).
NOTE: In Intercom mode, the pending calls correspond to incoming call
requests (normal and emergency call).
To Next Page
Loading...
