Danfoss FC 300 Design Guide

FC 300 Design Guide
How to Program
9-65 Profile Number
Option:
Read only
0-0
*
0
Function:
This parameter contains the profile identification.
Byte 1 contains the profile number and byte 2
the version number of the profile.
NOTE
This parameter is not visible via LCP.
9-70 Edit Set-up
Option:
Factory setup [0]
*
Setup 1 [1]
Setup 2 [2]
Setup 3 [3]
Setup 4 [4]
Active setup [9]
Function:
Selecttheset-uptobeedited.
Select Set-up 1-4 [1]-[4] to edit a specific set-up.
Select Active set-up [9] to follow the active
set-up selected in par. 0-10.
Select Factory set-up [0] for default data. This
option can be used as a data source to return
the o ther set-ups to a known state.
This parameter is unique to LCP and fieldbuses.
See also par. 0-11 Edit set-up.
9-71 Save Data Values
Option:
*
Off [0]
Store edit setup [1]
Store all set-ups [2]
Function:
Parameter values changed via Profibus are not
automatically stored in non-volatile m
emory. Use
this p arameter to activate a function that stores
parameter values in the EEPROM non-volatile
memory, so changed parameter values
will
be retained at power-down.
Select Off [0] to deactivate the non-volatile
storage function.
Select Store edit setup [1] to store all parameter
values in the set-up selected in par. 9-70 in the
non-volatile memory. The selection returns to Off
[0] when all values have been store d.
Select Store all set-ups [2] t o stor e all parameter
values for all set-ups in the non-volatile memory.
The selection returns to Off [0] when all parameter
values have been stored.
9-72 Drive Reset
Option:
*
No action [0]
Power-on reset [1]
Power-on reset prep [2]
Comm. option reset [3]
Function:
Select Powe r-on reset [1] to reset the frequency
converter upon power-up, as for power-cycle.
Select Comm. option reset [3] to reset the P rofibus
option only, useful after changing cert ain settings
in parameter group 9-**, e.g. par. 9-18.
When reset, the frequency converter disap pears
from the fieldbus, which may cause a
communication e rror from the master.
9-80 Defi ned Parame ters (1)
Array [1000]
Opti
on:
No LCP access
Read-only
0-999
9
*
0
Function:
This parameter displays a list of al l the
defin
ed frequency converter parameters
available for Profibus .
9-81 Defi ned Parame ters (2)
Array [1000]
Option:
No LCP access
Read-only
0 - 9999
*
0
*
default setting ()display text []value for use in communication via serial communication port
219
MG.33.B
6.22 - V LT is a registered Danfoss trademark

Danfoss FC 300 Specifications

General

Brand	Danfoss
Model	FC 300
Category	DC Drives
Language	English