Danfoss FC 300

FC 300 Design Guide
How to Program
" Parameter Selection
Parameters for FC 300 are grouped into various parameter groups to e asily select the correct
parameters for optimized operation of the adjustable frequency drive.
0-xx Operation and display parameters
• Basic settings, set-up handling
• Display and Local Control Panel parameters for choosing readouts, setting up
selections, and copying functions
1-xx Load and motor parameters, including all load- and motor-related parameters
2-xx Brake parameters
• DC brake
• Dynamic brake (resistor brake)
• Mechanical brake
• Over-voltage control
3-xx References and ramping parameters includes DigiPot function
4-xx Limits and warnings; setting of limits and warning parameters
5-xx Digital inputs and outputs, including relay controls
6-xx Analog inputs and outputs
7-xx Controls; setting parameters for spee d and process control
8-xx Communication a n d o ption parameters for s etting of FC RS-485 and FC USB port parameters.
9-xx Profibus pa rameters
10-xx DeviceNet and CAN Fieldbus parameters
13-xx Smart Logic Control parameters
14-xx Special function parameters
15-xx Drive information pa rameters
16-xx Readout parameters
17-xx Encoder option parameters
150
MG.33.B6.22 - VLT is a registered Danfoss trademark