Danfoss FC 300 Design Guide

FC 300 Design Guide
How to Program
" Changing of Data Valu e, Step-by-Step
Certain parameters can be changed step-by-step or infinitely variably. This applies to Motor Power
(par. 1-20), Motor Voltage (par. 1-22) and Motor Freque n cy (pa r. 1-23).
The parameters are changed both as a gro up of numeric data values and as nu-
meric data values infinitely variably.
" Read-out and Programming of In-
dexed Parameters
Parameters are indexed when p lace d in a rolling stack.
Par. 15-30 to 15-32 contain a fault log which can be read out. Choose a parameter, press [OK],
and use the up/down navigation keys to scroll thro ugh the value log.
Use par. 3-10 as another example:
Choose the parameter, press [OK], and use the up/down navigation keys to scrol
lthroughthe
indexed values. To change the parameter value, select the indexed value and press [OK].
Change the value by using the up/down keys. Press [OK] to accept the new setting. Press
[CANCEL] to abort. Press [Back] to leave the parameter.
145
MG.33.B6.22 - VLT is a registered Danfoss trademark

Danfoss FC 300 Specifications

General

Brand	Danfoss
Model	FC 300
Category	DC Drives
Language	English