Danfoss FC 300 Design Guide

FC 300 Design Guide
How to Program
" Quick T ransfer of Parameter Settings
Once the set-up of a d rive is complete, we
recommend that you store the data in the LCP or
on a PC via the MCT 10 Set-up Software Tool.
Data storage in LCP:
1. Go to par. 0-50 LCP C opy
2. Press the [OK] key.
3. Select “All to LCP”
4. Press the [OK] key.
All the parameter settings are now being stored in the LCP as indicated by the progress
bar. When 100% is reached, press [OK].
NOTE
Stop the motor before performing this operation.
You can now connect the LCP to another adjustable frequency drive and copy the parameter
settings to this adjustable frequency drive as well.
Data transfer from LCP to drive:
1. Go to par. 0-50 LCP C opy
2. Press the [OK] key.
3. Select “All from LCP”
4. Press the [OK] key.
The parameter settings stored in the LCP are now transferred to the drive indica ted by
the progress bar. When 100% is reached, press [OK].
NOTE
Stop the motor before performing this operation.
139
MG.33.B6.22 - VLT is a registered Danfoss trademark

Danfoss FC 300 Specifications

General

Brand	Danfoss
Model	FC 300
Category	DC Drives
Language	English