FC 300 Design Guide
How to Install
" The FC 300 Software Dialog
Data storage in PC via MCT 10 Set-Up Software:
1. Connect a PC to the unit via USB com port
2. MCT 10 Set-up Software
3. Choose "Read from drive"
4. Choose "Save as"
All parameters are now stor ed.
Data transfer fr om PC to drive via MCT
10 Set-Up Software:
1. Connect a PC to the unit via US B com port
2. MCT 10 Set-up Software
3. Choose "Open" - stored files will be shown
4. Open the approp riate file
5. Choose "Write to drive"
All p arameters are now transferred to the drive.
A separate manual for MCT 10 Set-up
Software is available.
119
MG.33.B6.22 - VLT is a registered Danfoss trademark
To Next Page
Loading...
