FC 300 Design Guide
How to Install
" Residual Current Device
You can use RCD relays, multiple protective grounding or grounding as extra protection,
provided that local safety regulations are complied with.
If a ground fault appears, a DC content m ay develop in the faulty current.
If RCD re lays are used, you must observe local regulations. Relays must be suitable for
protection of 3-phase equipment with a bridge rectifier and for a brief discharge on power-up;
see section Ground Leakage Current for further information.
125
MG.33.B6.22 - VLT is a registered Danfoss trademark
To Next Page
Loading...
