Enter/Exit Programming Mode
Product Reference Guide
263
BATCH FEATURES
Batch Mode
This option specifies whether to store labels in the handheld while discon-
nected from the base. Options are as follows:
• Disabled — The handheld will not store/batch labels.
• Automatic — The handheld will store labels to RAM when the handheld
go
es out of range and is disconnected from the remote device.
• Manual — The handheld will always store labels to Flash memory. The user
must
manually send the stored labels to the remote device using a special
"batch send" label.
Batch Mode = Disabled
Batch Mode = Automatic
Batch Mode = Manual
Send Batch
When the scanner is configured in Manual Batch Mode, use the following bar
code to initiate sending of labels stored in batch memory.
NOTE
Do not scan an ENTER/EXIT PROGRAMMING MODE label in conjunction with this
bar code.
To Next Page
Loading...
