Delta VP3000 Series - Page 535

Chapter 8 Troubleshooting｜VP3000
526
ID No.
Fault Name
Descriptions
30
EEPROM write error
(cF1)
Internal EEPROM cannot be programmed
Action and Reset
Action Condition
When the firmware detects failure of parameter EEPROM write in, the cF1 fault
occurs.
Action Time
cF1 acts immediately when the drive detects the fault
Fault Treatment Parameter
No
Reset Method
Manual reset
Reset Condition
Immediately reset
Record
Yes
Cause
Corrective Actions
Internal EEPROM write in error
Press RESET key or reset the parameter to the default setting, if cF1 still exists,
return to the factory for repair.
Reset parameters to default. If cF1 still exists, return to the factory for repair.
Cycle the power, if cF1 still exists, return to the factory for repair.