Delta VP3000 Series - Page 536

Chapter 8 Troubleshooting｜VP3000
527
ID No.
Fault Name
Descriptions
31
EEPROM read error
(cF2)
Internal EEPROM cannot be read
Action and Reset
Action Condition
When the firmware detects parameter data error, the cF2 fault occurs.
Action Time
cF2 acts immediately when the drive detects the fault
Fault Treatment Parameter
No
Reset Method
Manual reset
Reset Condition
Immediately reset
Record
Yes
Cause
Corrective Actions
Parameter EEPROM cannot be
read
Press RESET key or reset the parameter to the default setting, if cF1 still exists,
return to the factory for repair.
Reset parameters to default. If cF2 still exists, return to the factory for repair.
Cycle the power, if cF2 still exists, return to the factory for repair.