Delta VP3000 Series - Page 62

Chapter 2 Mechanical Installation｜VP3000
53
Frame F – Type 1
Applicable models: VFD110VP43AFTCA
1. Refer to the following table for the assembling accessories, quantities and screw torque.
No.
Accessories
Qty (pcs)
1
Screw M4xL8 (Screw torque: 14–16 kg-cm / 12.2–13.9 lb-in. / 1.37–1.57 Nm)
2
2
Control clips
3
3
Screw M4xL20 (Screw torque: 14–16 kg-cm / 12.2–13.9 lb-in. / 1.37–1.57 Nm)
6
4
Control EMC plate
1
5
Screw M5xL15 (Screw torque: 24–26 kg-cm / 20.8–22.6 lb-in. / 2.35–2.55 Nm)
2
6
Output EMC plate
1
7
Output EMC clip
1
8
Screw M4xL20 (Screw torque: 14–16 kg-cm / 12.2–13.9 lb-in. / 1.37–1.57 Nm)
2
2. Fasten the accessories as shown in the figure below.
Figure 2-73
3. Install the above EMC plate and control clips onto the AC motor drive, refer to the installation
location shown in the figure below.
Figure 2-74