Delta VP3000 Series - Page 660

Chapter 10 Accessories | VP3000
651
Environment
Noise Immunity
ESD (IEC 61800-5-1, IEC 61000-4-2)
EFT (IEC 61800-5-1, IEC 61000-4-4)
Surge Test (IEC 61800-5-1, IEC 61000-4-5)
Conducted Susceptibility Test (IEC 61800-5-1, IEC 61000-4-6)
Operation/ Storage
Operation: -10–50ºC (temperature), 90% (humidity)
Storage: -25–70ºC (temperature), 95% (humidity)
Shock / Vibration
Resistance
International standards: IEC61800-5-1, IEC60068-2-6 / IEC61800-5-1,
IEC60068-2-27
Table 10-25
⚫ Installation
Connecting CMC-EIP01 to Network
1. Turn off the power of the drive
2. Open the cover of the AC motor drive
3. Connect a CAT-5e network cable to the RJ45 port on the
CMC-EIP01, as shown in the figure on the right.
Figure 10-35
RJ45 Pin Definition
PIN
Signal
Definition
PIN
Signal
Definition
1
Tx+
Positive pole for
data transmission
5
--
N/C
2
Tx-
Negative pole for
data transmission
6
Rx-
Negative pole for
data receiving
3
Rx+
Positive pole for
data receiving
7
--
N/C
4
--
N/C
8
--
N/C
Table 10-26
Table 10-27
Figure 10-36
⚫ VP3000 Communication Parameters Settings for Connecting to Ethernet
When the VP3000 is connected to an Ethernet network, set up the communication parameters
for it according to the table below. The Ethernet master is only able to read and write the
frequency words and control word of VP3000 after the communication parameters are set.
Parameter
Description
Set Value (Dec)
Definition
A1-00
EX1/EX2 Switch Src
0
EX1 selection
A1-01
EX1 OPER Cmd Src
10
COM Card
C1-00
EX1 Main & Aux FREQ Math
0
0: Main FREQ
C1-01
EX1 Main FREQ Src
4
COM Card
n5-00
EtherNET Decoding Method
0 or 1
Delta drive decoding method
n5-01
EtherNET IP Configuration
0
Static IP (0)
n5-02
EtherNET IP Address 1
192
IP address 192.168.1.5
n5-03
EtherNET IP Address 2
168
IP address 192.168.1.5
n5-04
EtherNET IP Address 3
1
IP address 192.168.1.5