DGSHAPE DE-3 - Checking any Point on Engraving Data Using a Workpiece (Point Preview)

Checking Any Point on Engraving Data Using a Workpiece (Point Preview)
Procedure
A
Set the workpiece.
" P. 38 "Setting the Workpiece"
B
Close the front cover.
C
Press [ENTER/PAUSE].
D
Start Dr. Engrave Plus.
If engraving data is already open, proceed to step
H
.
E
Click [Open].
F
Select the data to engrave.
G
Click [Open].
F
G
Previewing before Engraving
121
Chapter 5 Various Engraving Methods