If the Error Occurs Again
There is a possibility that the spindle unit is defective. To replace the spindle unit, contact your authorized Roland
DG Corporation dealer.
"102B-0000" The spindle motor temperature is too high.
Level 2
Error Situation/Cause
• The tool is worn.
• A workpiece that cannot be engraved by this machine is being used.
• The engraving parameters are too strict.
• The Z origin has been set incorrectly.
Action
Procedure
A
Turn off the power.
B
Turn on the power.
C
Press [ENTER/PAUSE].
D
Review the tool, workpiece, or engraving parameters.
" P. 87 "Considering Engraving Parameters"
E
Set the Z origin.
" P. 108 "4. Install the cutter and set the Z origin point."
If the Error Occurs Again
There is a possibility that the spindle unit is defective. To replace the spindle unit, contact your authorized Roland
DG Corporation dealer.
Responding to an Error Message
149
Chapter 6 Appendix
To Next Page
Loading...
