DGSHAPE DE-3 - Checks and Preparation before Engraving; Checking the Flow of Engraving Operation

Checks and Preparation before Engraving
Checking the Flow of Engraving Operation
P. 25 "Checks and Preparation before Engraving"
Check the conditions, material and tool required to start engraving.
P. 26 "Checking Engravable Workpieces"
P. 27 "Determining the Item to Create and Required Material and Tool"
P. 28 "Creating Engraving Data"
Create engraving data using Dr. Engrave Plus.
Determine the design and draw
P. 35 "Setting the Engraving Parameters"
P. 38 "Starting Engraving"
Set the workpiece and tool, and send the engraving data to this machine.
P. 38 "Step 1: Setting the Workpiece"
P. 39 "Step 2: Setting the XY Origin"
P. 41 "Step 3: Installing a Character Cutter/Parallel Cutter"
P. 51 "Step 4: Checking the Engraving Parameters"
P. 54 "Step 5: Starting Engraving"
25
Chapter 3 Basic Engraving Methods