Checking Engravable Workpieces
Material
• Acrylic
• Modeling wax
• Aluminum
• Brass
• Wood
• Chemical wood
etc.
Size
Size that can be stably xed in place.
On this machine, an adhesive sheet is used to x the workpiece in place. The workpiece can be large and can stick
out of the workpiece table, but you must be able to stably x it in place.
* XY operating range (workpiece table size): Width × Depth: 305 × 230 mm (12.0 × 9.1 in.)
305 mm (12.0 in.)
230 mm (9.1 in.)
Checks and Preparation before Engraving
26
Chapter 3 Basic Engraving Methods
To Next Page
Loading...
