DGSHAPE DE-3 - 1000-000* the % Limit Switch was Not Found; 1017-0000 the Cover was Opened During the Spindle Rotating

"1000-000*" The % limit switch was not found.
* The name of the axis (X, Y, Z, or a combination of these axes) is displayed for %.
Level 3
• 1000-0001: X axis
• 1000-0002: Y axis
• 1000-0004: Z axis
Error Situation/Cause
Operation is inhibited by cutting waste or an obstruction.
Action
Procedure
A
Turn off the power.
B
Remove any objects blocking operation of the machine and any accumulated cutting
waste.
" P. 68 "Cleaning after Engraving Finishes"
C
Turn on the power, and then press [ENTER/PAUSE].
Resume operation.
"1017-0000" The cover was opened during the spindle rotating.
Level 1
Error Situation/Cause
The front cover was opened while the spindle was rotating, and so the motion of the spindle was stopped to
ensure safety.
Action
* Do not open the front cover while the spindle is rotating. Doing so may aect the engraving results.
Procedure
A
Close the front cover.
B
Turn the [Dial] and select [Continue] or [CancelJob].
C
Press [ENTER/PAUSE].
Responding to an Error Message
145
Chapter 6 Appendix