DGSHAPE DE-3 - Chapter 6 Appendix

125
Chapter 6 Appendix
Troubleshooting (Machine Problems) ....................................................................................126
The Power Does Not Turn On ......................................................................................... 126
Initial Operations Are Not Performed or Fail ............................................................126
The Operation Button Does Not Respond When Pushed ....................................126
The USB Cable/LAN Cable Has Come Loose during Engraving .........................126
The Machine Does Not Move When Engraving Data Is Sent ..............................127
The Spindle rotates but Does Not Move From Its Position
When Engraving Data Is Sent .........................................................................................127
The Spindle Does Not Rotate .........................................................................................127
Descent Does Not Stop ....................................................................................................128
Loud Noise or Unpleasant Noise during Engraving...............................................129
Troubleshooting (Engraving Quality Problems) ..................................................................130
Engraving Is Not Performed on the Expected Position ........................................130
Cutting-in Depth Is Not Uniform (When Nose Unit Is Used) ..............................130
Cutting-in Depth Is Not Uniform (When Nose Unit Is Not Used) ......................130
The Tool Leaves Tracks at Places Where Cutting-in Starts
or Where Lines Change Direction ................................................................................. 131
An Engraved Bottom Surface Is Rough or Burring Remains ............................... 131
Engraved Lines Are Uneven or Wavy ...........................................................................132
Troubleshooting (Installation) ...................................................................................................133
Driver Installation Is Impossible ....................................................................................133
Uninstalling the Driver .....................................................................................................137
Installing the Driver Separately .....................................................................................140
Installing the Software and the Electronic-format Manual Separately ...........142
Responding to an Error Message .............................................................................................. 144
Locations of the Power Rating and Serial Number Labels ..............................................151
Connector Specications.............................................................................................................152
Expansion Port ....................................................................................................................152
Machine Specications ................................................................................................................153
External View ........................................................................................................................153
Work Area ..............................................................................................................................154
Workpiece Table Installation Area Dimensional Drawing....................................155
Laser Pointer Irradiation Area ........................................................................................155
Main Specications ............................................................................................................156
Chapter 6 Appendix