6 Click [OK].
The [Engraving Parameters] screen closes.
H
Click [OK].
" P. 54 "Step 5: Starting Engraving"
Using a Character Cutter/Parallel Cutter (without Nose Unit)
Perform engraving without using the nose unit in the following situations:
¾ When you do not want to attach the vacuum adapter
¾ When hollowing
However, the Z-axis origin is xed, so to engrave at a uniform engraving depth, the engraving surface must be
level.
WARNING
Never inadvertently touch the computer or handy panel while performing this
task.
Unintended operation of the machine may lead to you being caught in the
machine.
WARNING
Securely fasten the cutting tool and workpiece in place. After securing in place,
make sure no spanners or other articles have been left behind inadvertently.
Otherwise, such articles may be thrown from the machine with force, posing a
risk of injury.
CAUTION
Be careful around the cutting tool.
The cutting tool is sharp. Broken cutting tools are also dangerous. To avoid injury,
exercise caution.
CAUTION
The machine contains blades and other sharp components.
Be careful not to touch the tool tip or any other sharp edges. Doing so may cause
injury.
Using Various Tools
104
Chapter 5 Various Engraving Methods
To Next Page
Loading...